Before removing the processor board, check the following areas:

  • Verify that the wires to the hopper motor are connected
  • Verify that the roll-pin is good
  • Test for 110 VAC across J/P l9-11 & 12
  • If 110 VAC is missing, then trace back for a broken connection
  • If 110 VAC is good, then replace the hopper SSR and test
  • Check for obstructions in the hopper
  • Use another hopper to determine if the motor seems bad

If that doesn’t work, try the following steps:

  • Replace the processor board with a “known good” one
  • If the processor board seems bad, check eBay for replacement or repair service
  • If the processor board is good, then replace the motherboard
  • To repair the motherboard, use this diagram to isolate the bad trace
  • If the motherboard and processor board are good, then use this diagram to test for wire continuity
Manuals and Documentation

Manuals and Documentation

The Player's Edge-Plus family of field service manuals contain information required to configure, troubleshoot and repair a Player's Edge-Plus machine.

View all posts

Add comment